Nowadays, there are more and more self priming pumps used, but after using corrosion-resistant centrifugal pumps, we need to operate more exhaust ports. So, how should self priming pumps exhaust after use? Take a look, the editor will share with you three common exhaust outlets and one method.
1. When filling water with a pump, it is necessary to install a butterfly valve at the overflow port of the self suction pump to close the valve. First, pour a small amount of water into the straight drinking machine and block it. After the pump is discharged, it indicates that the internal water of the self suction pump is full and can be shut down to work.
2. A funnel-shaped water filling device will be installed at the drainage outlet. This method involves making a funnel-shaped device and inserting it into the bottom drainage of the pump. Water will be filled into the self priming pump from the funnel-shaped device. However, it should be noted that a proper sealing treatment should be applied when no more water is needed.
3. If the self suction pump can be used to fill the exhaust pipe of a gasoline engine with water, when the diesel engine drives the self suction pump to work, the refrigerant can be filled with water through the multi-directional exhaust effect of the diesel engine. The application method is to purchase a dedicated injector technology device for diesel engine exhaust valve extraction, which is installed on the corrosion-resistant submersible pump and marine diesel engine exhaust pipe.
The above is the method for self suction pump exhaust. The editor reminds users again that after using the corrosion-resistant booster pump, they must perform various operations on its exhaust to avoid entering the surrounding air in advance and affecting the normal operation of related equipment.